Pressure Washer Nozzle Storage

NOTE: This design requires 5 gaskets or the nozzles will not be held properly.

This is a holder for pressure washer nozzles. It holds 5 nozzles:
* 0 degree - Red
* 15 degree - Orange
* 25 degree - Green
* 40 degree - White
* 65 degree - Black

You can obviously put any nozzle in any position but these are the 5 most common nozzles and the values are displayed on the holder.

The holes are sized for a gasket that is
* inner diameter (ID): ½"
* outer diameter (OD) 13/16"
* thickness: 9/32"
* groove diameter 5/8"
* groove width 1/16"

I found these at Ace Hardware in the USA, part number 55057-G. They were $0.79 each and is the most expensive part of the holder since you need 5. The cost of the print was under $0.25. The gasket should fit with a bit of clearance that allows the holder to swing without binding. This is necessary because when you insert/remove the nozzle, the gasket needs a bit of room to deform.

The sizes and colors are raised in the model and can be