Thingiverse
Prime Tower Calibration Piece
by JuusozRandom
3
Downloads
1
Likes
0
Makes
A simple prime tower calibration piece.
I'd recommend using a White/Red or Transparent/Red combo, as these will produce the most visible results.
Features:
- The two larger areas are for checking what the colors are actually supposed to look like.
- The mixture area has two platforms at different heights, as I noticed the mixture often changes between two layers.
- Optimized for 0.2mm layer height.
When optimizing the prime tower in Cura, make sure it has a hole in the middle. If it doesn't, your printer will not complete the minimum priming required. Also keep in mind that the prime tower size needs to change based on layer height.
I'd recommend using a White/Red or Transparent/Red combo, as these will produce the most visible results.
Features:
- The two larger areas are for checking what the colors are actually supposed to look like.
- The mixture area has two platforms at different heights, as I noticed the mixture often changes between two layers.
- Optimized for 0.2mm layer height.
When optimizing the prime tower in Cura, make sure it has a hole in the middle. If it doesn't, your printer will not complete the minimum priming required. Also keep in mind that the prime tower size needs to change based on layer height.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
