princess in the throne

Another one…. I have enabled 1 pause to change the first 2 colours but the final change has to be done during printing . I changed the red one to white . You have time to do it just dont forget it. The filament changes were too close and i could not enable another pause to be sure. Enjoy and post your makes! Project: princess in throne.hfpPrint at 100% infill with a layer height of 0.04mm with a base layer of 0.12mmThe Model is 156.26x200mm in sizeYou may print at higher layer heights below the Min Depth of 0.48mmThe Max Depth is 2.6mm and the Actual Depth is 2.7mmFilaments Used: PLA BambuLab Basic Black Transmission Distance: 0.3 PLA BambuLab Basic Blue Gray Transmission Distance: 3 PLA BambuLab Basic Red Transmission Distance: 4 PLA BambuLab Basic Gold Transmission Distance: 5 PLA BambuLab Basic Pumpkin Orange Transmission Distance: 5.5 PLA BambuLab Basic Beige Transmission Distance: 8 PLA BambuLab Basic White Transmission Distance: 5This print uses 7 unique filamentsSwap Instruction