Pringle Rhombus Pot/Planter

This design was inspired by a rhombus. Each rhombus in the planters/pots/pen holder is slightly curved like a pringle to make for a stunning, modern look. Print Settings:Using vase mode produces strong prints, along with 3 bottom layersTo achieve a watertight seal on the spiked planter (or to make sure that it is watertight), turn off spiral vase, turn top layers to 0, infill to 0, and walls to 2 or 3To achieve an even stronger/watertight print, go into filament settings, and set flow rate to 135%It prints good in any filament0.2 mm layer height or lower produces details betterThe model can be scaled to your liking (make sure to scale all directions evenly)