Pringles Dispenser

I present to the fine folks of Thingiverse a solution to a problem that has plagued large handed individuals since the dawn of time. Pringle tube to small for man hand, no fit. A simple twist of the patent pending self rising Pringles dispenser will reward you with a delicious bounty of potato snacks.

It should print without supports. The tolerances are tight but work with minor fitting. I had to deburr the parts and clean off any dots or over extrusions.

Assembly is straight forward with one exception. The sled that threads into the outside threaded tube threads much easier in one direction. Test the fit first before snapping the sled on to the inside tube. It snaps over the tabs easy but getting it off is difficult.

Pay careful attention to the magnet orientation. You need to make sure the same polarity is matched all the way around the sled and the plug. The magnets in the plug and slug should attract each other thus coupling the parts together magnetically. Super glue i