Thingiverse
Print In Place Button
von Wacky0Zack
2
Downloads
8
Likes
0
Makes
Designed up this Button to test 3D printed springs and because I thought it was cool.
Printing:
Infil Any (I did 20%)
No Support
Adhesion not needed (but recommended)
After printing the button shaft might be slightly adhered to the body of the button, with a push down on the button it will release any unwanted connections.
Printing:
Infil Any (I did 20%)
No Support
Adhesion not needed (but recommended)
After printing the button shaft might be slightly adhered to the body of the button, with a push down on the button it will release any unwanted connections.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
