Print-In-Place Clamshell Container

Print-In-Place Clamshell ContainerClip ModelNothing extra required.Magnet ModelsMagnet model requires 3mmx2mm magnets. You can use the ones from Maker Supply (see below).Please make sure the polarity of the top magnet is pointing the correct direction before inserting.Magnets With CoversInstructionsPrint at 0.2mmYou will need to add pauses at the following heights to add the magnets:10.6mm (layer 53 @ 0.2mm)85.2mm (layer 426 @ 0.2mm)Tolerances are tight, please insert carefully as to not dislodge the print from the bed.PausingIn Bambu Studio, slice and slide the slider down to the layer. Right click on the + and Add pause print.Magnets No CoversThere is tolerance to add a dab of glue in the hole.Multi-Material ModelsPlease note that the order of the STLs matters! The icons MUST BE LAST in the STL list for them to print properly. I have numbered the STLs for convenience. You should only have 1 number each for each model.If you want to save a lot of print time, make the top accent color