Thingiverse
Printable Chicken Coop
door Phyrex-firestorm
11
Downloads
8
Likes
0
Makes
This is a chicken coop that I designed and printed to house my pet chicken, Marceline. This print eats a ton of filament and time, and REQUIRES A LARGE FORMAT PRINTER!
Maximum dimensions of these parts is 385mm high, 380mm wide, 380mm long. This entire print was designed for a 400x400x400 build volume. Using my settings, this entire coop consumed about 44 pounds, or around 22kg of plastic and took 17 days to print. Be sure you have plenty of material, and a very stable power supply. It may also be advisable to have a filament runout sensor, print recovery, and/or a camera setup to keep an eye on things.
Fully assembled, the coop is about 30"x30"x30" (76.2x76.2x76.2cm), and can support at least 20 pounds. I haven't tested the weight rating too hard, but it was enough to hold 2 of the 5kg filament spools, which is where I got the numbers.
There is a 5th leg hole in the center of the coop for extra support, if needed.
Mounting points in the roof plates (the leg holes) allow for
Maximum dimensions of these parts is 385mm high, 380mm wide, 380mm long. This entire print was designed for a 400x400x400 build volume. Using my settings, this entire coop consumed about 44 pounds, or around 22kg of plastic and took 17 days to print. Be sure you have plenty of material, and a very stable power supply. It may also be advisable to have a filament runout sensor, print recovery, and/or a camera setup to keep an eye on things.
Fully assembled, the coop is about 30"x30"x30" (76.2x76.2x76.2cm), and can support at least 20 pounds. I haven't tested the weight rating too hard, but it was enough to hold 2 of the 5kg filament spools, which is where I got the numbers.
There is a 5th leg hole in the center of the coop for extra support, if needed.
Mounting points in the roof plates (the leg holes) allow for
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
