Thingiverse
Printable DSLR Mirrorless Camera Tripod
door jahnj0584
23
Downloads
95
Likes
0
Makes
I was not happy with what else was available to print so I designed and made my own. IMO It's much better and printed in about 3hrs on a Bambu A1 mini. Pictured with a 375g body and a 300gr lens.
Base: 0.16, 2.4mm walls, 20% infill
Legs: 0.08-0.2 adaptive, 3 walls, 15% infill
PLA if you don't intend to let it bake in the sun.
Key Features:
1) Sits flat even when back legs are removed
2) 46.2* of tilt available
3) Rigid mechanical lock at full extents of range
4) Lightweight
5) Designed around FDM print "limitations"
6) Only 4 screws needed!
1x 1/4-20x 1.75"
2x 1/4-20x 3/4"
1x 1/4-20x 1/2"
2x 1/4-20 Hex nuts (You could print these as well or modify the base to be tapped. I included a step file. Remove the
hex and reduce the thru hole to be .205")
-You can buy 4x 1.75" ones and trim them to length via dremel or hacksaw
-You can also use 3x D-ring tripod screws if you'd like to make this tool-less.
In my p
Base: 0.16, 2.4mm walls, 20% infill
Legs: 0.08-0.2 adaptive, 3 walls, 15% infill
PLA if you don't intend to let it bake in the sun.
Key Features:
1) Sits flat even when back legs are removed
2) 46.2* of tilt available
3) Rigid mechanical lock at full extents of range
4) Lightweight
5) Designed around FDM print "limitations"
6) Only 4 screws needed!
1x 1/4-20x 1.75"
2x 1/4-20x 3/4"
1x 1/4-20x 1/2"
2x 1/4-20 Hex nuts (You could print these as well or modify the base to be tapped. I included a step file. Remove the
hex and reduce the thru hole to be .205")
-You can buy 4x 1.75" ones and trim them to length via dremel or hacksaw
-You can also use 3x D-ring tripod screws if you'd like to make this tool-less.
In my p
jahnj0584 publiceert ook op
22 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!