Thingiverse
Printable egg-bot legs
por jhitesma
49
Descargas
20
Likes
0
Makes
I had some really ovoid plastic eggs I wanted to print on and needed to lower my pen arm so the bottom of it was below the base of my egg-bot. I kind of wanted the whole thing higher anyway for better ergonomics.
These are included in the onshape design of my re-redrawn eggbot (included as a source here) if anyone wants to modify them.
Should work on any eggbot that uses this same spacing between the bottom rails.
These are included in the onshape design of my re-redrawn eggbot (included as a source here) if anyone wants to modify them.
Should work on any eggbot that uses this same spacing between the bottom rails.
jhitesma también publica en
21 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
