Printable FOOT for LED Bridge

The original concept and model LED Bridge Lamp by OPOSSUMS is amazing- it just has a few problems. For example, the FOOT in the original has overhangs that causes printing stringing and sags or requires extensive filament wasting support. I did some cleanup of the foot to remove some unneeded hanging parts and to add fillets to the overhangs both outside and inside. This should print much better than the original.

(Revised 4-Aug-16)
This revision should fix the final "not printer friendly" aspect at the inside top surface. It was an unsupported span but it is now arched up to the top to print cleaner. I also ran it through the Netfabb repair tool before uploading to be sure it is "clean".

(Revised 8-Aug-2016)
One last little cosmetic detail that was bugging some users was patched up. If you printed KB2, you are OK, but KB3 does have the mounting lugs more firmly connected inside.