Thingiverse
Tools
Voir le modèle
Printable Hand Vise
686
Téléchargements
423
Likes
5
Makes
When working with small models sometimes my fingers just are too big. So I made a fully printable hand vise.
Print everything in PLA with a layer height of 0.2mm or lower. Support is not needed. The thread is close to M12 and should work directly after printing. Lubricating the thread is recommended - I am using candle wax for that. If you want, you can re-cut the thread with an M12 tapper, but that should not be necessary.
For the hinges I designed hinge rivets. To install the claws insert the claws and the hinge rivets, heat up a screwdriver and press it on the small end of the rivet. The rivet will melt in place.
Disclaimer:
This work by blecheimer is licensed under CC BY-NC-SA 4.0.
You are not allowed to copy this model to other 3D printing websites without my permission.
Print everything in PLA with a layer height of 0.2mm or lower. Support is not needed. The thread is close to M12 and should work directly after printing. Lubricating the thread is recommended - I am using candle wax for that. If you want, you can re-cut the thread with an M12 tapper, but that should not be necessary.
For the hinges I designed hinge rivets. To install the claws insert the claws and the hinge rivets, heat up a screwdriver and press it on the small end of the rivet. The rivet will melt in place.
Disclaimer:
This work by blecheimer is licensed under CC BY-NC-SA 4.0.
You are not allowed to copy this model to other 3D printing websites without my permission.
blecheimer publie également sur
235 modèles supplémentaires sur 3 autres plateformes
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
