Thingiverse
Printable spool holder without bearings
por MarcusVoss
17
Descargas
13
Likes
0
Makes
This is a spool holder which exept for a few screws is completely pritable even on smaller printbeds (>140x140mm)
You dont need any radial ball bearing, even so you can use one for extra smnoothness.
There a two alternatives for the side parts (choose either 2xB or 1xA + 1xB)
I also included spool adapterts for either 56mm or 52mm inner diameter.
If you need another size, just let me know in the comments.
Other parts you need:
2 m5 screws
4 m3 screws
You dont need any radial ball bearing, even so you can use one for extra smnoothness.
There a two alternatives for the side parts (choose either 2xB or 1xA + 1xB)
I also included spool adapterts for either 56mm or 52mm inner diameter.
If you need another size, just let me know in the comments.
Other parts you need:
2 m5 screws
4 m3 screws
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
