Printable X/Y Linear Rail

This is the 5th version of my printable linear rail, I've gotten everything to finally work correctly. This can be used as a drop in replacement for a 3d printer's X or Y axis. It's rail system is designed to connect together to form any needed length.

This machine hopefully will be my entry for the Gada prize.


Update 06/16/2011:
I worked out a few modifications to the shuttle. Now the lower half of the shuttle can be printed as well, this removes:
4x 5/16(8mm) nuts
2x 5/16(8mm) bolts
2x 5/16 washers

-The next to go is going to be replacing the front 5/16(8mm) hardware with all printed parts. I'm trying to pare this down just the motor and the printed parts.

-I also redesigned the Large helical gear to incorporate the 608 bearing embedded inside of it. think this is an advantage of trying to use 2 bearings in the pillow block. The large helical gear is also now held in place by a printed 8mm bolt 40mm long. This removes one additional piece of hardware.

-The sh