Printed Droid Modular Control Unit (MCU) Panels

Here are some additional panels for PrintingBuddy's MCU. These panels are for the AstroCAN Pro Dual Board, the 20A Relay, and the Single Benduino offered from Printed Droid. I had taken the original STL files and just cut and pasted parts together using TinkerCAD. Specifically for the dome 20A fuse panel I used the original Dome Panel that uses an XT60 Female connector and combined it with a single blank. Then I added holes to route cabling. For the Benduino I just used the original Blank and added holes for cabling and standoffs, and for the AstroCAN board I combined files to make a panel big enough for the board and cut holes for cabling and standoffs. By no means am I pro at this just having fun learning. Hope these files help. :-) The specific products these panels are for:https://www.printed-droid.com/kb/astrocan-pro-dual-board/https://shop.printed-droid.com/produkt/20a-relay-board/https://shop.printed-droid.com/produkt/benduino-single-2024/ Notes: The holes in the panels for