Printed truck V2: Frame

Finally got around to finishing the frame!
Just missing the driveshaft and gearbox then it's ready for a test.

There's 3 different ways to make this frame:
1) Print frontframe and rearframe, this requires a printing area of at least 225x76 millimeter.
2) Print frontframe_20cm and rearframe, one at a time and diagonally across the bed. This will just about fit, with some millimeter to spare if you have a 20x20cm bed to print on, I have tested it myself.
3)Print Split_Frontframe_20cm_A, Split_Frontframe_20cm_B, Split_Rearframe_A and Split_Rearframe_B then join them with 4mm rods and glue, this way you can print on an even smaller bed if done separately and diagonally.

Hardware needed:
8x M3x16 for the 4-links.
8x M4x10(or shorter) for the ninjaflex springs
2x M4x20 for the frame lock
2x 4mm rod, 70-80mm long for the frame reinforcement.

You can check out the assembly video for this over at my youtube:
http://www.youtube.com/c/MrCrankyfaceProjects

2016-04-20 Edit: Ad