Printer Power Supply Cover V2

Sometimes people tripping over your cord and smashing your power supply cover presents an opportunity for improvement.

If you are so inclined I would suggest investigating something that passes formal UL, ULC, CSA or other applicable standards for where you live but in the spirit of "run with what you brung" here is V2 of the cover design that integrates an on/off switch, plug and fuse.

This is a one piece sleeve design that incorporates mounting tabs as I mount it to the outside of my enclosure with two screws through the printed cover and one on a standoff at the mounting point of the top of the supply. This is for the smaller 20 amp supply that comes with many printers including my Tronxy P802E.

It is printed with supports and a picture is posted showing print orientation with supports still intact. In order to have support only in the areas needed in Cura I have set "Minimum Support X/Y distance" to 4mm.

Picture posted of supply it's intended for. Notable features of t