Thingiverse
Printer Status NeoPixel Corner Bracket
0
Download
0
Likes
0
Makes
A simple, compact bracket designed to replace a corner bracket on your printer. It houses a circular 7 Neopixel array that measures 25mm, which I purchased through zyltech (link below).
There are a few options. The first is one piece and is completely flat, I originally designed it for my transparent PETG printer. The other is a 2 piece design so any color combo can be used, with a few insert options - flat, beveled, and rounded.
The intent is a minimal printer status indicator with Marlin 2.0+ neopixel support.
IMPORTANT: These arrays have powered output leads (5v) on the opposite side of the input connections. The output connections in this setup will be mounted against the aluminum extrusion to allow the input wires to come out of the opening on the opposite side. You will need to tape or otherwise cover these connections or the extrusion itself so no contact is made to the aluminum. Leaving these contacts exposed runs a very high risk of shorting out your neop
There are a few options. The first is one piece and is completely flat, I originally designed it for my transparent PETG printer. The other is a 2 piece design so any color combo can be used, with a few insert options - flat, beveled, and rounded.
The intent is a minimal printer status indicator with Marlin 2.0+ neopixel support.
IMPORTANT: These arrays have powered output leads (5v) on the opposite side of the input connections. The output connections in this setup will be mounted against the aluminum extrusion to allow the input wires to come out of the opening on the opposite side. You will need to tape or otherwise cover these connections or the extrusion itself so no contact is made to the aluminum. Leaving these contacts exposed runs a very high risk of shorting out your neop
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
