PrintNC - Cable Chain supports

Cable chain supports I made up for my PrintNC machine.

PrintNC Tubing Size: 3 x 2 x 0.12"

Drag Chain: Uxcell R55 25mm x 57mm Plastic Open Type Cable Wire Carrier Drag Chain

Used two lengths of 1" x 1" x 0.125" Aluminum Angle to support the Cable Chain behind the X-Axis tubing using four of the X_Bottom parts.

My X-Axis tubing is four inches longer than stock, all hanging over the right side of the right Y-Axis rail. I attached the Y-Axis cable chain on the overhanging part of the X-Axis tubing.

Used M5 machine screws to support the the printed pieces to the rectangular tubing and to secure the cable chain to the printed parts or aluminum angle. The aluminum angle is supported to the printed parts with #6 x 1/2" flat head screws. The holes in the aluminum were chamfered so the screw heads were flush. The aluminum angle closest to the 3x2 tubing is supported by two screws to each printed piece.

Used template six from the PrintNC files to drill the two holes in the side