Thingiverse
printrboard 90 degree
por pen25
1
Descargas
2
Likes
0
Makes
modified to make stronger. i removed the tabs to hold the board in and strengthened the sides and added the fan location. will add a top half with fan mount later. there is a 2mm step to allow a top to slide over the bottom and added the skp. this was imported off the original stl so it wook allot of work to clean up
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!