Thingiverse
PrintrBoard Case
door Lord_Vader
10
Downloads
12
Likes
0
Makes
This is a Printrboardcase for my Rev.D board.
It has a 40mm-Fan mount and two 8mm holes for a 40mm Extruded-Aluminium (8mm slot).
The two square holes in the top may be used for ATX power.
I printed this in PETG due to warping (Case) and ABS (lid).
The holes for the lid and the fan are for M3 (threading) but you can use selftapping screws
It has a 40mm-Fan mount and two 8mm holes for a 40mm Extruded-Aluminium (8mm slot).
The two square holes in the top may be used for ATX power.
I printed this in PETG due to warping (Case) and ABS (lid).
The holes for the lid and the fan are for M3 (threading) but you can use selftapping screws
Lord_Vader publiceert ook op
26 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
