Thingiverse
Printrbot Pen Holder (Repaired)
von wd5gnr
4
Downloads
6
Likes
0
Makes
I wanted to try the Printrbot Pen Holder but it needed repair to slice correctly (at least in Slic3r). Based on the comments, I wasn't the only one who noticed so all I did to this was repair the STL file. It prints fine.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!