Thingiverse
Printrbot Play USB holder
von fukanchik
38
Downloads
22
Likes
1
Makes
Printrbot Play USB connector holder.
WARNING: Uploaded STL fits into my particular printer and USB cable. Yours might require size customization!
WARNING: Make sure cable enters the socket easliy when holder is in place! Otherwise you would eventually break your socket. Adjusting PEG vertical size will allow to customize this.
Motivation:
Printrbot Play USB socket is designed to break and fall out. It is hanging below the board on four tiny legs holding the weight and wobbling of the cable.
Luckily mine fell out 10 days before warranty end and I got free replacement. Still I don't expect the new one to last for long, so I designed this holder.
Other than that I like this printer model.
WARNING: Uploaded STL fits into my particular printer and USB cable. Yours might require size customization!
WARNING: Make sure cable enters the socket easliy when holder is in place! Otherwise you would eventually break your socket. Adjusting PEG vertical size will allow to customize this.
Motivation:
Printrbot Play USB socket is designed to break and fall out. It is hanging below the board on four tiny legs holding the weight and wobbling of the cable.
Luckily mine fell out 10 days before warranty end and I got free replacement. Still I don't expect the new one to last for long, so I designed this holder.
Other than that I like this printer model.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
