Printrbot Simple Metal Lights

Decided that there just wasn't enough lighting to see what I was printing. So I designed a two-part light bracket that can be mounted the Printrbot simple metal aluminum handle. The light "sled" is designed for 8-10mm wide strip LEDs, with channels for wiring, etc., built into the design.

This was designed to be printed on a Printrbot simple metal with the X-axis upgrade. The length of the parts is too long (220mm or so) to be printed in the standard 150cm3 available on the Printrbot simple metal. I also have the Z-axis upgrade, but that isn't necessary for this print...but you will need the aluminum handle and an ATX PSU.

To assemble, you'll need the following:

* Led strip lights (automotive accent lights work great for this)
* (8) 10-10mm x 3mm hex cap screws
* A spare 4-pin Molex connector
* Soldering iron and some solder
* Heat shrink tubing or electrical tape
* Zip ties

Assembly instructions can be found on my blog, but assembly is pretty straightforward.
* Pri