Thingiverse
Printrbot Spool Spacer - Spool guide addon
von Tormentist
22
Downloads
12
Likes
2
Makes
This is an addon to nmackes' guide/bumper that prevents the spool from catching on the bolts: http://www.thingiverse.com/thing:636176
His design did a great job for that problem, but then I noticed the spool itself sometimes gets in the way when the arm goes way up the Z axis. I created this part as an addon that clips in the bumper from nmackes.
\*updated STL to fix orientation (Z and Y were swapped), I positioned the overhanging clip on the side of the fan for an easier print.*
\*WIP: I recently bought spools that are too wide (95mm) to fit properly and am working on a new model that will accommodate both the narrow and wide ones I have. Uploaded the longer one, still an alpha version as I didn't have any time to print it yet, YMMV.*
His design did a great job for that problem, but then I noticed the spool itself sometimes gets in the way when the arm goes way up the Z axis. I created this part as an addon that clips in the bumper from nmackes.
\*updated STL to fix orientation (Z and Y were swapped), I positioned the overhanging clip on the side of the fan for an easier print.*
\*WIP: I recently bought spools that are too wide (95mm) to fit properly and am working on a new model that will accommodate both the narrow and wide ones I have. Uploaded the longer one, still an alpha version as I didn't have any time to print it yet, YMMV.*
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
