Thingiverse
Printrbot z axis extender
door eth2222
1
Downloads
3
Likes
0
Makes
After adding insulation and glass to my print bed I found I had taken at least a half inch of my z axis out of commission! These extenders bump the threaded rods about a inch up, extending the axis back to normal. I think this may only work if your print bed is higher than the usual. You will have to drill out the holes to your desired size.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
