Prism for Christmas Tree

Prism for X-Mas tree.It reflect the tree lights from any direction, even behind being transparent,Very Light, only 4g.it is quite fast to print: less than 1 hour.No support needed.The bottom (bottom when printing, top when on the tree) has a gap for a small cord to hang it on the X-Mas tree.IMPORTANT:For the best outcome, I used these settings:Wall Line: 1 (to make it as transparent as possible, using the PETG it comes out quite strong, I did not have transparent PLA)Infill: 0 (again to make it as transparent as possible)Support: NOP.S.I thank my wife for being my inspiring muse, as always Print Settings Supports: No Filament: PETG transparent Wall Line: 1Infill: 0Support: NO Very Light, 4g, but in PETG it come out strong.With only 1 wall line it come out trasparent and looks almost like glass.I suggest not to use vase mode ("Spiralize Outer Contour" for Cura) as the base has a gap for a small cord to hang it on the tree.Post-PrintingJust insert a small cord to hang it on the t