Prius sun visor extender

Rule #1 in 3D printing: Whenever possible, print stuff to make your wife happy.

The visor on our 2019 Prius has a extension to help cover the side window (where my wife usually sits on drives), but it's pretty short -- plus the visor doesn't have a ball socket so it's impossible to adjust the tilt of the visor to cover low sun angles.

So this is just a little slip-on part to help make the visor extender a bit bigger.

Print open end up, I used supports to the bed and a couple of abutment braces to hold it steady and a couple of tab anti-warping spots to make sure it didn't warp. Oh yeah, as a reminder, DON'T use standard PLA as it will be in the sun in a potentially hot vehicle.