Prize Cube Up/Down Gear

Arcade claw game uses a Brass gear that seems to be prone to shredding. Gear from Coast-to-coast cost like $30, it can be 3D printed in like 30 minutes, so pick your poison. Holes for set screw are NOT tapped/threaded, so you will have to do that yourself (or just add some locktite on the shaft over where the gear should go before hitting it into place and it should be fine). Tight fit around the shaft, so to get it on, you will have to very carefully hit it on using a mallet (and maybe a flat punch). This has only been tested on Prize Cube, but I do know that they use brass gears in other claw games too, so this MIGHT also work on those.