Thingiverse
Pro DnD Case V7
by Berko
133
Downloads
81
Likes
0
Makes
ITS BIGGER, IT HOLDS MORE DICE, ITS VERSION 7!!!
This Version Mods...!
- Holds 8 sets of 7 dice Comfortably!!! (cause we need more dice dammit!)
- Holds 4 Mins (25.4mm bases)!!!
- The Pencil area has been moved to a slide draw with magnets to the side of the box!!!
- The Tablet Stand has a Attachment for a portable Battery Charger!!!
Machine and Printing Settings:
Machine: Cocoon Create Touch (Wanhao I3 Plus) - 200x200x180mm
(you will need a bed of at least 200X200mm to print this!!!)
Amount of Plastic used: 75 - 80% of a 1KG roll of PLA (including support material)
Nozzle: 0.4mm @ 195C
Layer Height: 0.2mm
Bed: 60C - for the larger prints, A thin layer UHU glue stick helps!
Speed: 50-55mm/s
Infill: 15% - if you go lower in %, (eg 10%) you will need to increase top layers to 5 to
remove Bumps. on the slide lid, 100% infill is best!
Walls: Top 4 to 5 - Depending on your infill! above 20% around 3-4 is fine!
Walls; Bottom - 2 to 3 layers.
W
This Version Mods...!
- Holds 8 sets of 7 dice Comfortably!!! (cause we need more dice dammit!)
- Holds 4 Mins (25.4mm bases)!!!
- The Pencil area has been moved to a slide draw with magnets to the side of the box!!!
- The Tablet Stand has a Attachment for a portable Battery Charger!!!
Machine and Printing Settings:
Machine: Cocoon Create Touch (Wanhao I3 Plus) - 200x200x180mm
(you will need a bed of at least 200X200mm to print this!!!)
Amount of Plastic used: 75 - 80% of a 1KG roll of PLA (including support material)
Nozzle: 0.4mm @ 195C
Layer Height: 0.2mm
Bed: 60C - for the larger prints, A thin layer UHU glue stick helps!
Speed: 50-55mm/s
Infill: 15% - if you go lower in %, (eg 10%) you will need to increase top layers to 5 to
remove Bumps. on the slide lid, 100% infill is best!
Walls: Top 4 to 5 - Depending on your infill! above 20% around 3-4 is fine!
Walls; Bottom - 2 to 3 layers.
W
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
