Thingiverse

Pro trinket box (small)

door jimlee

26 Downloads

13 Likes

0 Makes

A printable box to fit an Adafruit Pro Trinket processor. (Smaller than original)

The processor & charging setup are mounted to the bottom of the box by a couple 2mm socket cap screws. Bosses for these are printed in the bottom of the box.

There is still room to fit a 150mah lipo battery and more left over for some sensors & wiring.

The processor : https://www.adafruit.com/product/2000
The charger : https://www.adafruit.com/product/2124
The switch : https://www.adafruit.com/products/805
The Lipo battery : https://www.adafruit.com/product/1317
The tiny little mounting screws : https://www.boltdepot.com/Product-Details.aspx?product=6358

adafruit adafruit trinket_ adafruit trinket pro arduino arduino box arduino case blinky container electronics enclosure LED Pro Trinket adafruit adafruit trinket_ adafruit trinket pro arduino arduino box arduino case blinky container electronics enclosure LED Pro Trinket adafruit adafruit trinket_ adafruit trinket pro arduino arduino box arduino case blinky container electronics enclosure LED Pro Trinket

Bron

Thingiverse

Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid

Eendelig Hardware nodig

Supports 1/3

Montage 0/3

Instellingen 1/3

Bedgrootte 0/3

Nabewerking 1/3

Printer

FDM / FFF

Bestandsformaat