Slicer Discord
Pro1000 case holder replacement (.45 ACP single stack) – Modelo 3D imprimible de Thingiverse Thingiverse

Pro1000 case holder replacement (.45 ACP single stack)

por LionFox
93 Descargas
41 Likes
0 Makes
Ver Modelo
DISCLAIMER: reloading cartridges is a dangerous endeavour.
All reloading and firing of reloaded ammunition is done at your own risk.

Do not attempt to reload until you have read and understood at least one printed reloading manual.
Always wear safety glasses when reloading.
Do not smoke while reloading.
Keep primers and powder away from heat and open flames.
Keep primers and powder where they cannot be accessed by children.
Work up your loads following the standard procedures described in printed load manuals.

To repeat, all reloading and firing of reloaded ammunition is done at your own risk, the author of the "Thing" (Case_holder_Pro1000.stl and all contents of the webpage "http://www.thingiverse.com/thing:1544225") assume no liability and no responsibility for death, injuries, or damage due to the use of said "Thing".

I purchased a used Lee Pro1000 set in .45 ACP, and found out that the case holder thingie was waaay too small for that caliber. I didn't want to order a
Fuente
Thingiverse
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

4 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección