Project Alpha "Project Omega spoof"

This is an imitation, in an opposite manner, of the Project Omega headphones by DMS. I made this for funsies, and I don't expect any further development. Headband is not included, and should be sourced elsewhere to fit a 100mm headphone enclosure.


Enclosure is glued together. First, apply a non woven tape to the front of the driver cage, and cut out the center triangle inside the "A". Apply a pva or tacky glue to the outside perimeter of the driver and insert into the driver cage from the back in line with the "A" on the front.

Solder the wire leads to the driver, The right pad is positive, left pad is negative.

Place the retainer on top of the driver and orient accordingly. It should fit snugly, but use adhesive if needed.

Figure out the orientation of the body and cage by placing on top of each other and rotating the body to the desired orientation according to how one will mount the headband in the 3 holes on the perimeter of the body. This can be confusing and may b