Thingiverse
ProMaster Maxx Fan Adapter
di MiseryBot
33
Download
34
Likes
1
Makes
This allows a Maxx Fan to be installed over the ribs in a ProMaster van roof.
There is a top/exterior and a bottom/interior.
You will need to print two of each piece. The pieces "puzzle" together.
You will probably want to print using PETG or ABS to survive the heat of the roof.
You would want to use some good sealer to glue and seal everything together so water cannot get in. SEM automotive seam sealer: https://amzn.to/3SrC6iq may work well.
Use at your own risk . . . I have not tested the outside/exterior of this design.
There is a top/exterior and a bottom/interior.
You will need to print two of each piece. The pieces "puzzle" together.
You will probably want to print using PETG or ABS to survive the heat of the roof.
You would want to use some good sealer to glue and seal everything together so water cannot get in. SEM automotive seam sealer: https://amzn.to/3SrC6iq may work well.
Use at your own risk . . . I have not tested the outside/exterior of this design.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!