Thingiverse
Propane gas-line cap
39
Downloads
12
Likes
0
Makes
This is a cap not for the propane tank, but for the valve/nozzle collar that connects to the propane tank. I went looking for one of these and didn't find one so...
Tested it and it works. I printed it with PETG at 0.2 and no supports. Might need a little cleanup on the inside diameter if the PETG gets stringy.
Print it with the handle part flat on the bed.
Note: It may seem like the inner opening is off center, but that's just an optical illusion because the threads are not symmetrical.
Tested it and it works. I printed it with PETG at 0.2 and no supports. Might need a little cleanup on the inside diameter if the PETG gets stringy.
Print it with the handle part flat on the bed.
Note: It may seem like the inner opening is off center, but that's just an optical illusion because the threads are not symmetrical.
TontoTraveler also publishes on
2 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
