Prosthetic Cover Connector

This is a modification of Djoko Kuswanto's (crewolprint3d) CRE-04_Cryptec_Pattern_Leg_Prosthesis-joint_cover for attaching CRE-04_Cryptec_Pattern_Leg_Prosthesis-cover_front and rear to a standard 30mm diameter prosthetic pylon. https://www.thingiverse.com/thing:2754691

The part is a very tight fit over a standard 30mm pylon and cannot be installed by flexing the part open. A pylon adapter will have to be removed from the pylon to install the joint cover. Most pylon adapters utilize 1 or two 4 mm or 5mm hex screws and prosthetists often use lock tight on the screws. Make sure and mark the alignment before removing so that all parts can be reassembled with the original alignment settings. See picutre for example of 4mm screw to loosen to remove the adapter. Note - look closely for the black mark on the pylon to realign the parts and the prosthetic foot is removed for purposes of the picture.