Thingiverse
Engineering
Zum Modell
Prosthetic Drumstick Holder
0
Downloads
3
Likes
0
Makes
This is an attachment for the octagonal adapter made by SPU Engineering, that allows a person who has lost a hand to hold a drumstick.
The Drumstick holder was also made by an SPU Engineering student.
- This takes roughly 2 hours to print.
- To use, slide a drumstick that is a little wider in diameter than 0.75 inches into the slot on the print, and attach the octagonal adapter to the octagonal mount made by SPU.
- I used a "Vic Firth Corpsmaster Signature Snare Stick - Ralph Hardimon Wooden Tip" wrapped in white electrical tape for this project.
The Drumstick holder was also made by an SPU Engineering student.
- This takes roughly 2 hours to print.
- To use, slide a drumstick that is a little wider in diameter than 0.75 inches into the slot on the print, and attach the octagonal adapter to the octagonal mount made by SPU.
- I used a "Vic Firth Corpsmaster Signature Snare Stick - Ralph Hardimon Wooden Tip" wrapped in white electrical tape for this project.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
