Thingiverse
Protection Case Winksoar Action Camera
von Rotorismo
4
Downloads
1
Likes
0
Makes
The print on the photo is a faulty prototype printed with Ninjatek Ninjaflex. Sides needed to be switched and this STL is the good one.
After printing the ring must be inserted from the inside before you put the camera in it.
After printing the ring must be inserted from the inside before you put the camera in it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!