Protective Wire Guide Bracket

This is a very simple protective wire-guide bracket is intended to allow a wire to pass over the edge of a roof or awning without rubbing or chafing. A through-hole enables a zip-tie to "lock" the wire into the guide tube.

**If you use these outdoors, make sure you print them out of PETG or some other weather-resistant filament.**

This wire guide uses no special slicer settings and can be printed without supports.

There are 3 variations included; the regular standoff, a slightly shorter version, and an alternate mounting model.
This design is nothing fancy but it works well for me to protect some wires from a solar panel from rubbing or contacting the edge of a metal awning.

Feel free to mix/remix/redesign to suit your needs!