Protest Sign Handle

Made to put an easy to hold handle on a protest sign. Made large to accommodate winter gloves. Can be scaled down slightly.

If using a large foamboard sign, do not attempt to hot-glue onto sign without using the 2-ply inlay method. The wind will rip the foam out of the sign and you'll have to run for your sign.
On smaller 1 ply foamboard signs, carefully score & remove the paper where the handle is going to be placed. Failure to do this will cause the handle to rip the paper off for you.

I recommend this method for using this handle on foamboard sign:
Items: Hot glue, 2 pieces of foamboard, an xacto knife or sumn.

On one of the sheets, mark and cut out 2 squares so the handle can fit snugly inside them. Place those squares in the middle of the sign.
Hot glue the 2 sheets of foamboard together to make a 2 ply board. Have a friend help with large full-size signs. Make sure to secure the middle where the handle will be well.
You can run hot glue on the outside edges of the board and us