Thingiverse
ProtoArc Keyboard EK01 Riser
von ijohnson
0
Downloads
0
Likes
0
Makes
The feet on the ProtoArc Backlit Bluetooth Ergonomic Keyboard EK01, while standard, are too short for my tastes.
The standard built-in feet give a rear keyboard rise of 3mm. These feet here will give either 4.5mm or 5mm (depending on which way you face them). As I am transitioning from a Microsoft Natural Elite 2/3 to this keyboard, I just need a bit more height at the back.
I printed using standard PLA at 10% infill at 0.15mm quality settings on a Pruse Mini+. It used 3.09m of filament and took my printer about 1h6m to print (each foot). I found a raft of 2 layers was sufficient to keep the bottom of the foot sharp.
The standard built-in feet give a rear keyboard rise of 3mm. These feet here will give either 4.5mm or 5mm (depending on which way you face them). As I am transitioning from a Microsoft Natural Elite 2/3 to this keyboard, I just need a bit more height at the back.
I printed using standard PLA at 10% infill at 0.15mm quality settings on a Pruse Mini+. It used 3.09m of filament and took my printer about 1h6m to print (each foot). I found a raft of 2 layers was sufficient to keep the bottom of the foot sharp.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
