Protomaker Complete (Reprap Mendel variant)

Protomaker, I upgraded because I wanted better performance and the ability to print with ninja flex and filaflex without issue (Success!)

Many of these parts have gone through many different tests and revisions, these are the final versions I've used as of May 17, 2017.

Made my own design based on my collection of 2mmx10mm pastic screws and for some reason I only had 5 mm 3m screws for the stepper motors. Designed a plug to hold the hot end in place, I wanted to remove and replace the hot end without taking off the extruder hotend.

Assembly is pretty straight forward, but instructions are always good.
As any reprap mendel, you'll need threaded rods, lead screw with flanged nut, smooth rods, nuts, bolts, tie wraps, motors, 5/8mm couplers, endstops 608 bearings, linear bearings, wires, arduino and ramps and stuff or equivalent, hot end and fans.

*Extruder block and extruder block 2 are the same, just flipped 90 degress. Same goes for the extruder plug. These are for two diff