Thingiverse
Proton Pack Centre Cover
door tgoacher
120
Downloads
63
Likes
6
Makes
UPDATE 2/12/17. This part was used in the Ghostbusters Station 6 fan film. Check it out on youtube at https://www.youtube.com/watch?v=RHMUsQqLmRg
A full size, 3D printable version of the Ghostbusters' proton pack centre cover.
Based on Steffan Otto's plans at:
http://www.gbfans.com/wiki/Stefan_Otto%27s_Prop_Plans
Print 2x CentreTubeMount.stl.
Join parts together with 3/8 #4 screws. Lower tube needs to be
fastened to motherboard with #4x 3/4 screws.
Print CentreDrill.pdf at 'actual size' for motherboard drill centres.
I used Big Boy plastic filler to blur the junction between parts 4 and 5.
UPDATE 24/11/14: Some people like the tube on the raised section
to be the same length (and therefore higher) than the lower tube.
Print CoverTubeTaller.stl instead of CentreTubeUpper.stl if this
is how you want it.
A full size, 3D printable version of the Ghostbusters' proton pack centre cover.
Based on Steffan Otto's plans at:
http://www.gbfans.com/wiki/Stefan_Otto%27s_Prop_Plans
Print 2x CentreTubeMount.stl.
Join parts together with 3/8 #4 screws. Lower tube needs to be
fastened to motherboard with #4x 3/4 screws.
Print CentreDrill.pdf at 'actual size' for motherboard drill centres.
I used Big Boy plastic filler to blur the junction between parts 4 and 5.
UPDATE 24/11/14: Some people like the tube on the raised section
to be the same length (and therefore higher) than the lower tube.
Print CoverTubeTaller.stl instead of CentreTubeUpper.stl if this
is how you want it.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!