Cults3D
€ Paid
Tool
Ver Modelo
ProTool Dock
0
Descargas
0
Likes
0
Makes
The ProTool Dock is a purpose-built desk organizer designed specifically for 3D printing and robotics workbenches, where a scattered mix of pliers, screwdrivers, files, and scrapers usually ends up in a messy pile next to the printer. Instead of generic pen-cup storage, this design uses a custom slotted tray system that holds each tool in its own dedicated, snug-fit slot — so every plier, cutter, and screwdriver has one specific place it always goes back to. This isn't just about tidiness; it's about muscle memory. After a few uses, you reach for the same slot every time without even looking, which matters a lot when you're mid-repair on a print head or wiring up a robotics board and need a tool fast.
The tray sits inside an outer holder box with a stepped, tiered profile: a tall rear section for long-handled tools (nose pliers, cutting pliers, wire cutters), a mid-height section for a 4-piece screwdriver set (large, small, precision, and a continuity/voltage tester), and a dedicated
The tray sits inside an outer holder box with a stepped, tiered profile: a tall rear section for long-handled tools (nose pliers, cutting pliers, wire cutters), a mid-height section for a 4-piece screwdriver set (large, small, precision, and a continuity/voltage tester), and a dedicated
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
