Prototype Magnetic Motor

Magnetic Motor - 3D Printed (DIY Educational Model) A printable magnetic-motor model designed for classroom demos, makers, and hobby experiments. The frame is fully 3D printed; hardware is standard and easy to source. The coil is hand-wound, and the rotor uses common 6201 bearings for smooth, low-friction motion. What’s included (STLs) Motor BaseMagnet BaseBearing SupportMotor post You will need (hardware & consumables) Bearings2× 6201 bearings Magnets 6× Neodymium magnets, 60×10×5 mm(“3 magnets per side,” total 6) Threaded inserts & screwsHeat-set brass inserts, M3 M3 screws and a few M3 washers as needed Coil & conductorEnameled copper magnet wire, 27 AWG– 100 turns per side of the coil former (i.e., wind 100 turns on each of the two long faces)5 mm conductive copper adhesive tape (for terminals/contacts and neat wiring) Recommended print settings (guide)Material: PLA or PETGLayer height: 0.20–0.28 mmInfill: 25–35% (gyroid or grid)Walls: 3–4 perimetersSupports: Off for most parts; en