Slicer Discord
Proxy Kon-Tar-Na ( SOV Heroscape Custom) – 3D-printbaar model van Thingiverse Thingiverse

Proxy Kon-Tar-Na ( SOV Heroscape Custom)

111 Downloads
76 Likes
0 Makes
Model downloaden
It has come to my attention that the Kon-Tar-Na figure from Confrontation is very hard to come by. So here you go. I'm going to be honest with you, its not my best remixing work , and I took a lot of artistic liberties with how this model looks compared to the original model. Also I'm not 100 % sure is the scale is close to the original. I pretty much just measured picture I found on the internet and tried to get the ratios of the figure to match. ( I don't have the original model to compare it too) I'd appreciate any comments on this one. Do you think i went too far with the spikes? does it look too different from the original ? I may change this model in the future if I get feedback that I veered to far off. WIP, Havent printed it off yet either. If anyone has the actual Model, Please take some measurements of it and i will adjust this model to match it.

Also ...... Always remember........ Heroscape Lives On!!!!!!
Update 1-11-2020 cleaned up the file and adjusted the feet an
Bron
Thingiverse
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie