Prusa Mini Filament Guide

I wanted the filament to load into the Mini like on the Mk3 so I designed this bracket that bolts onto the T slot of the frame.

I found if the filament roll has a small amount of filament on it when the printer unloads it, the roll flys of the stand

You will need two M3 nuts, two M3x15 screws and a PC4-M6 Quick Fit connector.

Print two T-Nut 25 singles and the filament bracket.

The top hole will need tapping out 6mm, it is possible to screw in the connector without tapping but not so easy

If you want the filament roll holder I use its here:https://www.thingiverse.com/thing:3495735