Thingiverse
Prusa Mini / Mini+ Dragon Hotend Mount
von Spodesta
3
Downloads
0
Likes
0
Makes
Mount for the Dragon hotend remixed from the mosquito mount, I haven't test on the machine but I did mount the hotend on a test PLA print and it works very well.
Make sure to add the right back screw before mounting the fan spacer or it wont go in later.
Tight the fan before fully tightening the top 4 screws.
it uses the standard x carriage
Print both on ABS, PC, Nylon, ASA or other temp resistant filament, personally I will use CF-ABS.
Make sure to add the right back screw before mounting the fan spacer or it wont go in later.
Tight the fan before fully tightening the top 4 screws.
it uses the standard x carriage
Print both on ABS, PC, Nylon, ASA or other temp resistant filament, personally I will use CF-ABS.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
