Prusa Mk2S Hemera Mount

***Edit 1-3-20*** Moved the PINDA mount up 3mm, rounded off the right side of each mount and increased the pin holes by .05mm since mine printed a bit tight. Someone mentioned "find a way to mount the PINDA without a zip tie but there is just not enough meat on that part to do it with screws so I think a few ties would be sufficient.

*** Edit1-2-20 ***- Hemera arrived and I found out how dumb I was. Once the extruder was mounted several of the brass inserts were covered. I did not realize this since I never mounted the extruder until today. Just a dumb moment. Here is the revised mount, Swapped out 2 brass inserts for pins and added 2 at the bottom and extended it just enough to capture the brass insets. I think this is acceptable at this point!

*** Reworked some features and added back a few brass inserts for rigidity.

*** Had to edit the brass inserts to only 3 since I left out the lower belt slot. I still think that will be more than sufficient since the original was held