PRUSA MK2S Light Bar Bracket

This is a light bar (or whatever else you want to mount on it) bracket for the PRUSA i3 MK2S. I wanted a mounting bracket that did not interfere with the extruder or the spool holder so i designed this to snap into the stock "hex" hole on the top Z axis brackets with no screws or fasteners required. Its very sturdy and will not come out even if you push down on the ends where the light mounts.

It has 2mm clearance over the top of the Z axis brackets to clear the smooth rod and lead screw. For mounting the LED bar there is a screw hole in the center of the mounting block for the metal clips. The light bar mounting angle is 30* which seems to work best for my setup. Left and Right are the same so just print 2 of these. I used 4 perimeters and 40% infill to limit flexing as much as possible but that maybe a little overkill and standard 2 perimeters and 20% are probably more than enough.